Operation Manual

E50
Instructions For Use. Page 5
BASIC OPERATION
BEFORE YOU SWITCH ON
Follow this routine before you
listen for the first time, and each time
you change any connections.
1 Check all the connections
to the E50 and your audio system.
2 Then check again.
3 Turn the volume control of
your amplifier to zero ( Fully anti-
clockwise).
4 Select “ Tuner” input via
your amplifier.
5 Now you can switch on the
power, tune your E50 tuner to the re-
quired broadcast and carefully ad-
vance the volume control of your am-
plifier to the level you desire.
6 Enjoy the music.
AERIAL CONSIDERATIONS
Before you will be able to extract
the maximum performance from any
tuner, it will be necessary to install a
good aerial system. This does not
inevitably mean an expensive aerial,
as the type needed by most households
in order to receive the stations within
a given service area can be quite
simple. However, do not expect to
receive a good signal with minimum
background noise if you are only
using a T-shaped ribbon. The best
advice we can give you is to contact a
local approved contractor, who
should be familiar with the reception
conditions in your area.
FLUORESCENT DISPLAY
The display panel, in conjunction
with the LED lights below, gives
information about the station tuned.
For example, the display below indi-
cates the station frequency, that it is
correctly tuned in, that it is being
received in stereo, and that the tuner is
in auto tuning mode.
OPERATION
POWER BUTTON
Press this button to turn the power
ON. Press again to turn the power OFF.
Note: Whenever the power is
turned ON, the station you were listen-
ing to last will be received automatically,
while the frequency of the station appears
in the display.
MANUAL/AUTO BUTTON
Press this button once and the indi-
cator marked “AUTO” will light up.
This indicates “AUTO” mode.
In this mode, press either the
“TUNE UP ” or “TUNE DOWN ”
buttons; the E50 will tune either up or
Press this button.This light shows status.