User manual

- ６ - MY575 SPOT
The Display Panel:
The Display Panel offers several features: you can set the starting address, switch on and off the lamp, run the
pre-programmed program or make a reset. It has been updated so if you have earlier my575 beware of the
changes! These updates are a direct result of customer feedback.
Probably the most important changes are:-
1. To change DMX address you must enter the Mode menu. You cannot just press the up and
down buttons to change the address.
2. The default for the lamp striking is from the board channel 14. The fixture’s lamp will not just
start up when you turn on the fixture.
The main menu is accessed by pressing (and holding) the Enter-button for 3 seconds until the display starts
flashing. Browse through the menu by pressing the Up-button. Press the Enter-button in order to select the
desired menu. You can change the selection by pressing the Up-button. Confirm every selection by pressing
the Enter-button. You can leave every mode by pressing the Exit-button. The functions provided are described
in the following sections on the next page.