User Manual GETTING STARTED? EASY. (1 8VHU 0DQXDO 5HIULJHUDWRU .6 .
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference.
• • • Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard.
CARE AND CLEANING • • • • WARNING! Risk of injury or damage to the appliance. • • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. This appliance contains hydrocarbons in the cooling unit. Only a qualified person must do the maintenance and the recharging of the unit. Regularly examine the drain of the appliance and if necessary, clean it. If the drain is blocked, defrosted water collects in the bottom of the appliance.
SWITCHING ON 1. Connect the mains plug to the power socket. 2. If the display is off, press ON/OFF. If DEMO appears on the display, the appliance is in demonstration mode. Refer to "Troubleshooting". The temperature indicators show the set default temperature. To select a different set temperature refer to "Temperature regulation". If the door remains open for some minutes, the light will turn off automatically. The light is reset by closing and opening the door itself. SWITCHING OFF 1.
The dynamic air cooling indicator is shown. The fan runs when the compressor is running. Repeat procedure steps to turn off function. 1. Press the Mode until the corresponding icon appears. The dynamic air cooling indicator flashes. 2. Press the OK button to confirm. DOOR OPEN ALARM An acoustic alarm will sound if the door is left open for a few minutes. The door open alarm conditions are indicated by: • a flashing Alarm indicator; • an acoustic buzzer.
1 The walls of the refrigerator are equipped with a series of shelves support so that the shelves can be positioned as desired. Some shelves must be lifted up by the rear edge to enable them to be removed. Do not move the glass shelf above the vegetable drawer to ensure correct air circulation. 2 2. Reposition the shelf as required. Do not move the big lower door shelf to ensure correct air circulation. MOVABLE SHELVES VEGETABLE DRAWER The drawer is suitable for storing fruit and vegetables.
time. If too cold, change to a higher temperature setting. CAUTION! Do not place food against or close to the temperature sensor (A). This can result in too cold temperatures. • If you want to check the temperature of food stored in the refrigerator, place a glass of water centrally in the cabinet, and put a proper thermometer with an accuracy of +/– 1 °C into it. After 6 hours the temperature can be monitored. The measuring shall be performed under steady-stated conditions (without changing the load).
DEFROSTING OF THE REFRIGERATOR Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside.
Problem 10 Possible cause Solution The temperature in the appliance is too high. Contact a qualified electrician or contact the nearest Authorised Service Centre. A rectangular symbol is shown instead of numbers on the Temperature Display. Temperature sensor problem. Contact the nearest Authorised Service Centre (the cooling system will continue to keep food products cold, but temperature adjustment will not be possible). The lamp does not work. The lamp is in stand-by. Close and open the door.
Problem Possible cause Solution DEMO appears on the display. The appliance is in demonstration mode. Keep the Mode pressed for approximately 10 seconds until a long sound is heard and display shuts off for a short time. Door is misaligned or interferes with ventilation grill. The appliance is not levelled. Refer to "Levelling". The temperature in the appliance is too low/too high. The temperature regulator is not set correctly. Set a higher/lower temperature. The door is not closed correctly.
Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre. ELECTRICAL CONNECTION • Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply.
DOOR REVERSIBILITY WARNING! Before carrying out any operations, remove the plug from the power socket. 1 CAUTION! To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations. 1. Remove the ventilation grille. Remove the upper filling and install it on the opposite side of the grille. 2. Lay down the appliance back side down on a wooden support. 3. Unscrew the hinge (1). 4.
. Raise the appliance and install the ventilation grill. 15. Put the cabinet in position. 4 2 CAUTION! Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. 3 1 Do a final check to make sure that: • All screws are tightened. • The magnetic seal adheres to the cabinet. • The door opens and closes correctly. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet.
ENVIRONMENTAL CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
$