User Manual

12. CONFIG MENU
42
SEQUENCE Clears the active pattern’s sequence data. All presets will remain unchanged. A prompt
appears when you select this option. Press “YES” to clear, or “NO” to cancel the operation. Note that
no sequencer information is permanently lost until the pattern is saved. (To the same pattern slot.)
12.2 PROJECT
Select PROJECT to open the Project Manager. It lets you manage your projects and create, load, clear
and save projects. An inverted slot number denotes the active project. Use LEVEL/DATA to browse proj-
ects and then push LEVEL/DATA to open a popup menu that gives you the following options:
LOAD Loads the selected project. This operation overwrites the active project!
SAVE Saves the active project to the selected slot. If you wish to save the project to an empty slot
select a ----- slot at the bottom of the list. A NAMING menu opens where you can name the project
when you select this option.
DELETE Resets the project slot to a clean state. A prompt appears asking if you want to execute the
operation. Turn LEVEL/DATA to select YES or NO. Press LEVEL/DATA to execute.
To create a new project, select NEW at the top of the project list. The new project is empty. This opera-
tion overwrites the active project!
If you load a project or create a new one, it overwrites the active project. Be sure to save
your active project before you load or create a new project.
12.3 MIDI
In this menu, you find various sub-menus dealing with the MIDI functionality of Model:Cycles.
12.3.1 SYNC
Controls how Model:Cycles receives and sends MIDI clock and transport commands. Use LEVEL/DATA
to browse and change the settings.
CLK IN will, when set to ON, make Model:Cycles respond to MIDI clock and MIDI transport messages
sent from external devices.
CLK OUT will, when set to ON, make Model:Cycles transmit MIDI clock and MIDI transport messages.
PCH IN will, when set to ON, make Model:Cycles respond to incoming program change messages,
which is useful when wanting to select patterns externally. You set the MIDI channel for the program
change messages in the MIDI CHANNELS menu. For more information, please see “12.3.2 IN CHAN”
on page 43.
PCH OUT will, when set to ON, make Model:Cycles send program change messages when one
pattern changes to another. You set the MIDI channel for the program change messages in the MIDI