User Manual

12. CONFIG MENU
45
headphones if you want to turn up the MAIN OUT volume really loud. You can see the HP MAX setting as
a little headphones symbol when you turn the MAIN VOLUME knob.
12.4.2 INT OUT
Sets if Model:Cycles sends audio to the MAIN OUT and HEADPHONES OUT or not.
OFF sends no audio.
AUT sends audio unless you are sending and receiving audio over USB. If so, the Model:Cycles
detects this and sends no internal audio to MAIN OUT and HEADPHONES OUT.
ON sends audio.
12.4.3 TRK OUT
Sets if the separate tracks sends audio to the MAIN OUT, HEADPHONES OUT, and USB or not. Use the
[T1–T6] pads to toggle the tracks on and o.
12.4.4 DEL OUT
Sets if the delay eect sends audio to the MAIN OUT, HEADPHONES OUT, and USB or not.
12.4.5 REV OUT
Sets if the reverb eect sends audio to the MAIN OUT, HEADPHONES OUT, and USB or not.
12.4.6 USB GAIN
Sets the gain level of the audio sent from the USB audio host to the Model:Cycles. This setting only
aects the audio sent from the USB audio host to the analog MAIN OUT and HEADPHONES outputs.
(0 dB–+18 dB)
12.5 BACKUP
Here you can send and receive project or pattern data in SysEx format to a receiving device for backup via
the MIDI port or the USB port of the Model:Cycles.
When sending or receiving SysEx data, the MIDI ports or the USB port of the Model:Cycles must be con-
nected to the external sending/receiving device.
12.5.1 SENDING BACKUP PROJECT/PATTERN DATA
Press LEVEL/DATA to initiate SysEx data transfer of the current project. Use LEVEL/DATA to select if
you want to send project or pattern data.
Before initiating a SysEx send, first, make sure the receiving device is listening for data.
12.5.2 RECEIVING BACKUP DATA
Model:Cycles is continuously listening for SysEx data so you can at any time send backed up projects or
patterns to the device.