User Manual

10. KITS AND SOUNDS
27
pages. Once a kit has been selected, press [YES] to load it. The loaded kit are linked to the active pat-
tern. If the active kit is loaded, it will be reloaded to the state it was saved in.
10.2.3 SAVE KIT
Saves all the current kit related settings as a kit. When a kit is saved, it will be linked to the active pat-
tern. [YES] + [PLAY MODE] oers a shortcut to this command, saving the kit instantly to the same slot
and with the name of the kit unchanged. It is good practice to use the shortcut frequently to ensure kit
changes are saved.
When this menu is opened, the kit list will appear. The active kit is shown with inverted graphics. Select
the slot to which the kit will be saved by using the [ARROW] keys or the TRACK LEVEL knob. Press
[YES] to save to the selected slot. The NAMING screen, covered on page 17, will appear.
10.2.4 CLEAR KIT
Clears the content of the currently loaded kit, basically initializing it. When selecting this option a prompt
will appear. Press [YES] to clear the kit or [NO] to cancel the operation. Note that no kit information will
be permanently lost until the kit is saved to the same kit slot it was loaded from.
10.2.5 TRACK ROUTING KIT
Customizes track routing. The default setting is to use the TRACK ROUTING global settings found in the
GLOBAL SETTINGS menu. See section “14.6 TRACK ROUTING GLOBAL” on page 59.
If you want custom settings for the currently active kit, press [YES] to untick the USE GLOBAL SETTING
box and use the [ARROW] keys [UP] and [DOWN] to navigate the menu.
USE GLOBAL SETTING press [YES] if you decide to use GLOBAL settings after all. The <PADS>
shows what the current GLOBAL settings are for the drum tracks. <PADS> of a green color send to
main. Unlit <PADS> do not.
ROUTE TO MAIN highlight this option to customize which of the 12 tracks will send to the master ef-
fects (Distortion and Compressor) and main output. Use the [PADS] to activate/deactivate send from
the track of each corresponding pad. <PADS> of a green color send to main. Unlit <PADS> do not.
Note that each track still sends to its individual output.
SEND TO FX highlight this option to customize the send FX routing of the 12 tracks. Use the [PADS]
to activate/deactivate each corresponding track for sending to the send FX (Delay and Reverb).
<PADS> of a yellow color send to FX. Unlit <PADS> do not.
10.2.6 CONTROL IN 1 MOD
Opens the CONTROL IN 1 MOD setup for Control In 1. Basically this is like a performance macro that you
can control with CV or an expression pedal connected to the Control In 1 input (labeled EXP/CV IN 1 on
the Analog Rytm MKII back panel). The setup for the Control In 1 input can be found in the GLOBAL SET-
TINGS menu. For more information, please see “14.7 CONTROL INPUT 1” on page 59. This modulation
macro is configured the same way as a performance macro.