User Manual

10. KITS AND SOUNDS

RENAME renames the selected Sound.

EDIT TAGS opens a menu where Sounds can be tagged. Sounds can have any number of tags, but

only the ﬁrst two will be shown on the Sound list. Apply or remove tags by pressing [YES].

DELETE deletes the Sound.

SELECT ALL selects all Sounds in the list.

DESELECT ALL deselects all Sounds in the list.

TOGGLE enables or disables write protection for the selected Sounds. When a Sound is write pro-

tected it cannot be overwritten, renamed, tagged or deleted.

SEND SYSEX sends the selected Sounds as SysEx data.

• Sounds in the +Drive Sound library are organized into 16 banks, ranging from A to

P. Each bank can contain 256 Sounds. Use the [TRIG] keys to view only Sounds

located in a speciﬁc bank.

• You can preview the currently selected Sound by tapping the pad of the active

track. All Sounds available for the active track can be previewed. Please note that if

the previewed Sound is sent to the eects, the current eects settings will aect it.

• Several Sounds can be simultaneously aected by the commands available in the

SOUND OPERATIONS menu. Select/deselect individual Sounds by highlighting

them and pressing [YES].

• Press [FUNC] + [UP]/[DOWN] for faster scrolling in the Sound list.

10.5.3 CLEAR TRACK SOUND

Sets the PARAMETER page parameters of the active track to their default values. When choosing this

option, a prompt will appear. Press [YES] to reinitialize the parameters or [NO] to cancel the operation.

Note that no parameter information will be permanently lost until the kit is saved to the same slot it was

loaded from.

10.5.4 RENAME TRACK SOUND

Opens a NAMING screen where the Sound of the active track can be renamed.

10.5.5 SOUND SETTINGS

Opens a menu where various overarching Sound settings are found. These settings are stored to the

active kit. Use the [UP]/[DOWN] arrow keys or the TRACK LEVEL knob to scroll through the menu. Use

the [LEFT]/[RIGHT] arrow keys to change the settings.

MACHINE select the MACHINE with which the active track Sound will be generated. Only the

MACHINES available for the active track will be shown. To swiftly change MACHINE, use the shortcut

command by quickly pressing the ﬁrst [PARAMETER] key, SRC, twice. To ﬁnd out more about MA-

CHINES, see “APPENDIX D: MACHINES” on page 88.

CHROMATIC sets which parts of the Sound CHROMATIC mode, as well as the trig page NOT param-

eter, will aect:

• OFF means the pitch will not be aected at all.

• SYNTH aects the pitch of the Synth part only.

• SAMPLE aects the pitch of the Sample part only.

• SYN+SMP aects the pitch of both Synth and Sample parts.

ENV RESET sets the ﬁlter envelope behavior:

• OFF does not reset the envelopes for each consecutive trig (lets the cycle complete).

• FILTER resets the envelopes for each consecutive trig (default).