User Manual

10. KITS AND SOUNDS
36
Turn the knob counter-clockwise to scroll up the list, clockwise to scroll down the list. Tap the pad of the
active track while browsing to listen to the sample currently outlined.
Press [FUNC] and [YES] to replace a sample in one of the slots with one found in any of the sample direc-
tories. To learn more about sample directories, see “GLOBAL MENU” on page 51.
To select an outlined sample, press [YES]. Press DATA ENTRY knob D or [NO] to exit the list without se-
lecting a sample.
Sample selection may also be accessed by double-pressing the [SMPL] key.
10.9 EDITING THE FX
Select the FX track for editing by pressing the [FX] key. The FX track controls Analog Rytm MKII internal
send eects (Delay and Reverb) and master eects (Distortion and Compression). Editing the FX track is
similar to editing the Sounds of the drum tracks. The PARAMETER pages contain all FX parameters.
There are five PARAMETER pages for the FX track. Access the PARAMETER pages by pressing one of
the [PARAMETER] keys. Use the DATA ENTRY knobs A-H to change the parameters. The first two, Delay
and Reverb, are send eects: their parameters are set on the FX track, but their incoming signals are set on
the DEL and REV send parameters on the AMP page of each drum track. The following two, Distortion and
Compressor, are master eects: they condition all sounds with distortion or compression. The last page is
the dedicated FX track LFO, with which you can temper any of the parameters on the FX track with a cus-
tom low-frequency oscillation along one of seven possible waveforms, enabling - to name but one example
- tidal modulation of sound distortion. For complete explanations of the parameters on the FX track, please
see “APPENDIX B: FX TRACK PARAMETERS” on page 75.
DELAY controls the character, reverb send and volume of the delay send eect.
REVERB controls the character and volume of the reverb send eect.
DIST controls the amount and character of distortion applied.
COMP controls the behavior, volume and dry/wet mix of sound compression.
LFO controls parameters for the FX track LFO.
• FX and track parameter settings are stored as part of a kit. Don’t forget to save the kit and
give it a unique name once you have achieved the results you want, or simply press [YES]
+ [PLAY MODE] to quickly save the active kit with its name unchanged.
Set the master return level of the Delay and Reverb outputs on the FX track with the TRACK LEVEL knob.
These send eects also have individual volume parameters.