User Manual
11. THE SEQUENCER
47
Select the track that will be aected by pressing the corresponding [TRK] key. Select the accent value
by turning the TRACK LEVEL knob. The higher the value, the more accentuation will be added to accent
trigs.
While the ACCENT menu is open, the sequencer will display accent trigs. Place or remove accent trigs
by pressing the [TRIG] keys. If you wish to edit the step property on all tracks simultaneously, not just the
active track, press and hold [FUNC] key and then enter the trigs. If an accent trig is placed on the same
sequencer step as a note trig, the note trig will be accentuated.
• A note trig can be quickly accented. Keep the note trig pressed and press [BANK F].
An accent trig will automatically be placed on the same sequencer step as the note trig.
• Press a note trig/lock trig to quickly see if an accent trig is placed on the same se-
quencer step as the trig. If that is the case, the [BANK F] key will light up.
11.11.7 SWING
Adjust the swing setting of the pattern, to employ a propulsive, rhythmic groove. Access this menu by
pressing [FUNC] + [BANK G].
Set the SWING ratio to 51-80%, by turning the TRACK LEVEL knob or by pressing [ARROW] keys [UP]
or [DOWN]. The default setting is equal spacing, 50%. Customize the swing pattern, shown by lit [TRIG]
keys, using the [TRIG] keys.
11.11.8 PARAMETER SLIDE
The PARAMETER SLIDE menu makes it possible for the parameter values of two separate note trigs or
lock trigs of a track to slide between each other. Open the menu by pressing [FUNC] + [BANK H]. When
this menu is active, and [TRIG] keys are pressed, slide trigs will be placed on the sequencer. If you wish
to edit the step property on all tracks simultaneously, not just the active track, press and hold [FUNC]
key and then enter the trigs.
For a parameter value to slide between two trigs, it needs to be locked on one of the trigs. A locked pa-
rameter value will slide to the unlocked value and vice versa. To make the parameter value slide, place a
slide trig on the same sequencer step as the trig whose parameters you want to slide. The speed of the
slide is relative to the current tempo, and the slide is completed when the next trig is reached. Several
parameter values can slide at the same time.