User Manual

14. GLOBAL SETTINGS MENU

4. Drag and drop the samples to the Elektron Transfer main window. The samples will automatically be

transferred to a default directory (if no other is set in Elektron Transfer) “transfers-yymmdd” that is

created in the +Drive storage of the Analog Rytm MKII. Elektron Transfer automatically converts all

audio ﬁles to 16 bit, 48 kHz, mono audio ﬁles, the Analog Rytm MKII native audio format.

Analog Rytm MKII still supports transfer of samples via MIDI Sample Dump Standard (SDS) and Extend-

ed SDS using the C6 utility software. The default target directory of samples using this method, if no

other is set, is called INCOMING in the +Drive storage of the Analog Rytm MKII.

14.2.3 CREATING A NEW DESTINATION DIRECTORY

This procedure is only for when you use the Elektron C6 software transfer tool. If you use Elektron

Transfer you create a new destination directory in the Analog Rytm MKII directly from Elektron Transfer.

On the main screen when you view the samples in the +Drive, press [ARROW] key [RIGHT] to access

the right side menu. Select CREATE DIR to create a new directory by pressing [YES]. A naming screen

will appear. See section “6.5 THE NAMING SCREEN” on page 17. Give your new destination directo-

ry an appropriate name. Once the new directory has appeared on the main screen, open it by pressing

[YES]. In the initially empty directory, press [ARROW] key [LEFT] to open the left side menu. Highlight

UPLOAD HERE and press [YES].

Consequently, samples sent from a computer will be written into the new destination directory. Note that

any new or existing directory can be set to be the destination directory in a similar manner, accessing the

left side menu, except for the FACTORY directory which is write-protected. Any directory (again, except

the FACTORY directory) can be deleted or renamed by highlighting it, accessing the right-hand menu

and selecting DELETE DIR or RENAME.

• Make sure you have the latest version of the SysEx utility software C6 installed on your

computer to eciently and reliably transfer samples to the Analog Rytm MKII +Drive

storage. The C6 software can be freely downloaded from the Elektron website.

• If MIDI+USB is selected in the INPUT FROM and/or OUTPUT TO settings on the MIDI

PORT CONFIG menu (see below), MIDI data transfers will limit the USB speed. When

sending or receiving large chunks of data, make sure you use only the USB setting.

14.3 GLOBAL SLOT

Selects which of the four Global slots to use. Select the active slot by using the [LEFT]/[RIGHT] arrow

keys. Press [YES] to conﬁrm the selection. All changes made to a Global slot are automatically saved. A

slot stores the current conﬁguration of the sequencer, MIDI and track routing settings. All changes made to

a Global slot are automatically saved.

14.4 SEQUENCER CONFIG

Here settings relating to the sequencer can be found. Change settings by using the [LEFT]/[RIGHT] arrow

keys or the [YES] key.

QUANTIZE LIVE REC will when active quantize notes entered in LIVE RECORDING mode to complete

sequencer steps. When the setting is deactivated, live recorded notes will, where applicable, be aected by