User Manual

APPENDIX D: MACHINES
88
APPENDIX D: MACHINES
This appendix lists the parameters on the SRC page of the drum tracks. The parameters available are
determined by the MACHINE that has been selected. There are several MACHINES to choose from. See
“ANALOG RYTM CONTROLS” on page 14 (illustration) for drum track voice allocation.
The MACHINES below can be used on all tracks: BD, SD, RS, CP, BT, LT, MT, HT, CH, OH, CY and CB.
D.1 ALL
NONE (SYNTH DISABLED)
There are no parameters on the SRC page when it is disabled. Select DISABLE, then save, to be able to
make a sample-based Sound accessible, for loading and Sound Locking, on any of the 12 Tracks.
NOIS (WHITE NOISE GENERATOR)
LPF (LP Filter) sets the lowpass filter cuto frequency. (0–127)
LPQ (LP Resonance) sets the amount of resonance around the cuto frequency of the LP Filter. Zero
value quenches resonance altogether (0–127)
ATK (Attack) sets the length of the attack phase. (0–127)
DEC (Decay) sets the length of the decay phase. (0–INF)
HPF (HP Filter) sets the highpass filter cuto frequency. (0–127)
SWD (Sweep Depth) sets the depth of the LP Filter sweep. Negative as well as positive sweeps are
possible. (64–+63)
SWT (Sweep Time) sets the length of the sweep from the depth set by SWD. Low values result in
snappy sweeps, high values result in longer sweeps. (0–127)
LEV (Level) sets the volume of noise. (0–127)
PULS (POSITIVE/NEGATIVE POLARITY IMPULSE)
ATK (Attack) sets the length of the attack phase. (0–127)
DEC (Decay) sets the length of the decay phase. (0–127)