User Manual

10. THE SEQUENCER
31
VEL Sets the velocity curve fade out/fade in of the retrig (128–127). 128 corresponds to a complete
fade out during the set length, 64 fades out to half the velocity during the set length, 0 equals a flat
velocity curve with no fade, 64 fades into half velocity during the set length and 127 fades in completely
to full velocity during the set length.
10.5 PATTERN MENU
Use the PATTERN menu to perform pattern management. Press [PATTERN MENU] to open the menu. Use
the [UP] and [DOWN] arrow keys to move between the options. Press [YES] to confirm your selection. Exit
the menu by pressing [NO].
10.5.1 RENAME
Opens a NAMING screen where you can rename the active pattern.
10.5.2 CLEAR
• WHOLE PATTERN Clears the active pattern’s sequencer data and kit. A prompt appears when you
select this option. Press [YES] to clear, or [NO] to cancel the operation. Note that no pattern informa-
tion will be permanently lost until the pattern is saved to the same pattern slot that it was loaded from.
• KIT DATA Clears the active pattern’s kit. All sequencer data will remain unchanged. A prompt ap-
pears when you select this option. Press [YES] to clear, or [NO] to cancel the operation. Note that no
kit information will be permanently lost until the pattern is saved to the same pattern slot that it was
loaded from.
• SEQUENCE DATA Clears the active pattern’s sequence data. All Sounds will remain unchanged. A
prompt appears when you select this option. Press [YES] to clear, or [NO] to cancel the operation.
Note that no sequencer information are permanently lost until the pattern is saved to the same pattern
slot it was loaded from.
10.5.3 SAVE TO PROJ
You must have saved the project at least once before you can save pattern information.
• WHOLE PATTERN Saves the active pattern’s sequence data and kit to the +Drive. A prompt appears
when you select this option. Press [YES] to save, or [NO] to cancel the operation.
• KIT DATA Saves the active pattern’s kit to the +Drive. A prompt appears when you select this option.
Press [YES] to save, or [NO] to cancel the operation.
• SEQUENCE DATA Saves the active pattern’s sequence data to the +Drive. A prompt appears when
you select this option. Press [YES] to save, or [NO] to cancel the operation.
10.5.4 RELOAD FROM PROJ
You must have saved the pattern at least once before you can reload pattern information.
• WHOLE PATTERN Reloads the active pattern’s sequence data and kit from the +Drive. A prompt will
appear when you select this option. Press [YES] to reload, or [NO] to cancel the operation.
• KIT DATA Reloads the active pattern’s kit from the +Drive. A prompt appears when you select this
option. Press [YES] to reload, or [NO] to cancel the operation.
• SEQUENCE DATA Reloads the active pattern’s all sequence data from the +Drive. A prompt appears
when you select this option. Press [YES] to reload, or [NO] to cancel the operation.
10.5.5 IMPORT/EXPORT
Here you can manage the Sounds on the Digitakt.
• IMPORT SOUND Imports (copies) a Sound from the +Drive to the active pattern. Turn the LEVEL/
DATA knob or press [UP]/[DOWN] to scroll through the list. Press [YES] to select a Sound and then
press [TRACK 1–8] to select the track to where you want to assign the Sound.