User Manual

13. FX PARAMETERS
49
13. FX PARAMETERS
The Digitakt eect parameters are explained in this chapter.
13.1 EDITING THE FX PARAMETERS
The Digitakt’s Delay and Reverb are send eects and are set on a pattern level. It means that all the Sounds
in a pattern shares the same eect settings but have individual send levels to the eects. The Delay and
Reverb parameters are set on their respective PARAMETER page, but their incoming signals are set by the
DEL and REV send parameters on the AMP page of each audio track. Press [FUNC] + [FLTR] to edit the
Delay. Press [FUNC] + [AMP] to edit the Reverb. Use the DATA ENTRY knobs A-H to change the parameters.
DELAY controls the character, reverb send and volume of the delay send eect.
REVERB controls the character and volume of the reverb send eect.
• The FX parameter settings are stored as part of the pattern. Don’t forget to save the pat-
tern and give it a unique name once you have achieved the results you want.
13.2 DELAY
The Delay send eect takes the input signal, delays it in time and then rejoins it with the original signal.
Press [FUNC] + [FLTR] to access this parameter page.
13.2.1 TIME
Delay Time sets the delay time. It is relative to the current BPM and is measured in 128th notes.
(1.00–128.00)
TIME setting Divide ratio
1 1/128
2 1/64
2.67 1/48 (1/32T)
3 1/64.
4 1/32
5.33 1/24 (1/16T)
6 1/32.
8 1/16
10.67 1/12 (1/8T)
12 1/16.
16 1/8
21.33 1/6 (1/4T)
24 1/8.
32 1/4
42.67 1/3 (1/2T)
48 1/4.
64 1/2
96 1/2.
128 1