User Manual

15. SETTINGS MENU

OUT PORT FUNCTIONALITY selects what type of signal the MIDI OUT port will send.

• MIDI makes it possible for the port to send out MIDI data.

• DIN 24 will make the port send DIN 24 sync pulses. No MIDI data is transferred over the port when

this option is selected.

• DIN 48 will make the port send DIN 48 sync pulses. No MIDI data is transferred over the port when

this option is selected.

THRU PORT FUNCTIONALITY selects what type of signal the MIDI THRU port will send. The settings

are the same as for OUT PORT FUNCTIONALITY.

INPUT FROM selects the source Digitakt will receive MIDI data from.

• DISABLED will make Digitakt disregard any incoming MIDI data.

• MIDI will make Digitakt listen only to MIDI data sent to the MIDI IN port.

• USB will make Digitakt listen only to MIDI data sent to the USB port.

• MIDI+USB will make Digitakt listen to MIDI data sent to both the MIDI IN and USB ports.

OUTPUT TO selects the destination to which Digitakt will send MIDI data.

• DISABLED will stop Digitakt from sending out any MIDI data.

• MIDI will make Digitakt send MIDI data to the MIDI OUT port only.

• USB will make Digitakt send MIDI data to the USB port only.

• MIDI+USB will make Digitakt send MIDI data to both the MIDI OUT and USB ports.

If MIDI+USB is selected in the INPUT FROM and/or OUTPUT TO settings, MIDI data will

limit the USB speed. When sending or receiving large chunks of data, make sure you

only use the USB setting.

OUTPUT CH selects whether the knobs will send data on the auto channel or the track channel.

PARAM OUTPUT selects what type of MIDI messages the DATA ENTRY knobs will send. For information

about which CC/NRPN parameters that will be sent, please see “APPENDIX A: MIDI” on page 70.

• NRPN will make the knobs send out NRPN MIDI messages.

• CC will make the knobs send out CC MIDI messages.

ENCODER DEST controls whether the DATA ENTRY and LEVEL/DATA knobs sends MIDI data or not.

When set to INT, the knobs only aects the Digitakt and no MIDI data is sent. When set to INT + EXT,

the knobs aects the Digitakt and also sends MIDI data to external devices.

TRIG KEY DEST controls whether the [TRIG] keys sends MIDI data or not. When set to INT, the

[TRIG] keys only aects the Digitakt and no MIDI data is sent. When set to INT + EXT, the [TRIG] keys

aects the Digitakt, and also sends MIDI data to external devices. When set to EXT, the [TRIG] keys

do not aect the Digitakt but MIDI data is sent externally.

MUTE DEST controls whether activating/deactivating mutes will send MIDI data or not. When set to

INT, mute only aects the Digitakt and no MIDI data is sent. When set to INT + EXT, mute aects the

Digitakt and also send MIDI data to external devices. When set to EXT, mute sends MIDI data exter-

nally, but do not aect the Digitakt.

RECEIVE NOTES will, when active, make it possible to play Digitakt using an external MIDI keyboard.

RECEIVE CC/NRPN will, when active make it possible to control Digitakt parameters from an external

MIDI device sending CC/NRPN data.

15.3.3 CHANNELS

This menu handles the MIDI channel conﬁguration.

TRACK 1–8 selects the dedicated MIDI channel that is used to receive or send (by turning the knobs)