User manual

38
7b. Setting and starting the
programme with "delay start"
Once a programme and required options
have been selected (see point 7a.) to use
DELAY proceed as follows:
Press the DELAY push button.
The digital display will show "h 0".
If other options have been selected the
corresponding indicator lights will turn off, but
this will not modify the settings made previously.
Press the button again to select the number of
hours by which you wish to delay the
programme start (up to a maximum of 12
hours).
To set the time setting to zero press the
DELAY push button until "h 0" appears
in the digital display.
Close the door, an audible signal will confirm
the starting of the countdown.
The digital display shows the delay time
(flashing dots in the display indicate that the
countdown is going on), which will decrease
with steps of 1 hour.
Once the delayed time has elapsed the
programme will start automatically.
The opening of the door will not stop the
countdown.
8. To cancel a programme in
progress
To cancel a programme in progress, open the
door and press the "Cancel" push button.The
setting will be annuled and it is now possible to
select a new programme.
To stop a countdown in progress, open the door
and press the "cancel" push button, in the
digital display appears the number
corresponding to the selected programme. The
countdown has been cancelled but the setting
of the programme with eventual options remains
memorised.
9. At the end of the washing
programme
The dishwasher will automatically stop and
an intermittent audible signal will sound
when the programme has ended (with the
delay start the audible signal is
automatically excluded).
All indicator lights turn off and 3 flashing
horizontal lines will appear in the digital
display.
Open the door and switch off the
dishwasher by pressing the On/Off push
button.
Wait a few minutes before removing the
dishes; in this way they will be cooler and
the drying will be improved.
Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
Important!
In general it is not advisable to open the
door while the machine is working; if the
door is opened however, a safety device
ensures that the machine stops.
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished, as
steam may escape.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.