User Manual

9. PATTERNS AND SOUNDS
31
9.6.1 MODE
Activates the arpeggiator and controls how the arpeggiated notes are sorted.
OFF deactivates the arpeggiator.
TRUE plays the notes in the same order as they are inserted.
UP plays the notes in ascending order, from the lowest note to the highest, on a per octave basis.
DOWN plays the notes in descending order, from the highest note to the lowest, on a per octave
basis.
CYCL plays the notes first in ascending order, then in descending order.
9.6.2 SPD
Speed sets the speed of the arpeggiator. It is synchronized to the BPM of the project. (1/1–1/96).
9.6.3 RNG
Range sets the octave range of the arpeggiator. After each completed arpeggiator cycle, the arpeggiat-
ed notes are transposed one octave up. When the notes have reached the octave oset specified by the
RNG setting the notes are reset to their initial values. From there the octave transpose is started all over
again.
9.6.4 LEN
Length controls the length of the arpeggiated notes.
9.6.5 ARP LENGTH
Turn DATA ENTRY knob F to select the length of the arpeggio. The max length is 16 sequencer steps.
9.6.6 OFFSET
Oset selects the oset (note) value of the chosen arpeggiator step in semi-tones. The oset is from the
original note trig. The TRK KEY SCALE and TRK KEY NOTE settings found in the NOTES SETUP menu
aects the note values of the arpeggiated notes.
1. Press [LEFT] or [RIGHT] to select which arpeggiator step to oset.
2. Use DATA ENTRY knob E to set the oset.
3. Press [DOWN] to deacivate an arpeggiator step. Press [UP] to activate an arpeggiator step that
has been deactivated.