User Manual

12. MIDI TRACK PARAMETERS
56
12.3.1 CHAN
Channel sets the MIDI channel the track sends MIDI data to. If you set this parameter to OFF, it turns the
MIDI track o. Please note that this parameter cannot be parameter locked. (OFF, 1–16)
12.3.2 BANK
Bank sends a bank change message on CC 0 MSB. (OFF, 1–128)
12.3.3 SBNK
Sub Bank is sends a bank change message on CC 32 LSB. (OFF, 1–128)
12.3.4 PROG
Program Change sends a Program Change message. (OFF, 1–128)
12.3.5 PB
Pitch Bend controls the pitch bend data sent on the MIDI track. (OFF, 128.00–128.00)
12.3.6 AT
Aftertouch controls the aftertouch data sent on the MIDI track. (OFF, 0–127)
12.3.7 MW
Mod Wheel controls the modulation wheel data sent on the MIDI track. (OFF, 0–127)
12.3.8 BC
Breath controller controls the breath control data sent on the MIDI track. (OFF, 0–127)
12.4 SYN2 PAGE (MIDI SOURCE)
SYN2 page contains the same parameters as the SYN1 page. Press [SYN2] to access this parameter page.
12.5 FLTR PAGE (CC VALUE)
Here you can set the values of up to eight assignable CC commands. The default value of the parameters
on this page is OFF, meaning they are disabled and do not send out any data. Press and hold [FUNC] and
then press the DATA ENTRY knobs to enable them. You can then use the DATA ENTRY knobs to set the
parameter values as usual. Disable the parameters again by repeating the enabling procedure.
Press [FLTR] to access this parameter page.
12.5.1 VAL1-VAL8
CC 1–8 Value controls the values that the CC commands send. You specify the CC commands them-
selves on the AMP (CC SELECT) page. These parameters default value is OFF. Press [FUNC] + DATA
ENTRY knobs to activate the parameters and then turn the DATA ENTRY knobs to set a value. (OFF,
0–127)