User Manual

13. FX PARAMETERS
59
13. FX PARAMETERS
Here follows a description of the parameters on the CHORUS, DELAY, REVERB, and MASTER PARAMETER
pages.
13.1 EDITING THE FX PARAMETERS
The Digitone Keys’s Chorus, Delay, and Reverb are send eects and are on a pattern level. It means that all
the Sounds in a pattern shares the same eect settings but have individual send levels to the eects. You
set the Chorus, Delay, and Reverb parameters on their respective PARAMETER page, but their incoming
signals are set by the CHR, DEL, and REV send parameters on the AMP page of each synth track. Press
[FUNC] + [SYN2] to edit the Chorus. Press [FUNC] + [FLTR] to edit the Delay. Press [FUNC] + [AMP] to
edit the Reverb. Use the DATA ENTRY knobs A-H to change the parameters.
The FX parameter settings are stored as part of the pattern. Don’t forget to save the pattern
and give it a unique name once you have achieved the desired results.
13.2 CHORUS
The chorus can be used to widen sounds, enhance the stereo image or add subtle movement to sounds.
Press [FUNC] + [SYN2] to access this parameter page.
13.2.1 DPTH
Depth sets the depth of the LFO modulation of the chorus.
13.2.2 SPD
Speed sets the speed of the LFO modulation of the chorus.
13.2.3 HPF
High-pass filter sets the highpass filtering of the input signal.
13.2.4 WDTH
Width sets the stereo width of the chorus.
13.2.5 VOL
Mix Volume adjusts the volume of the chorus signal.
13.2.6 DEL
Delay Send sets how much of the wet chorus signal to send through to the delay.
13.2.7 REV
Reverb Send sets how much of the wet chorus signal to send through to the reverb.
13.3 DELAY
The delay send eect takes the input signal, delays it in time and then adds it to the original signal.
Press [FUNC] + [FLTR] to access this parameter page.