User Manual

9. THE SEQUENCER
27
1. In GRID RECORDING mode, press and hold one or several [TRIG] keys and then turn SWING to access
the TRIG NUDGE menu that shows the time oset for the chosen sequencer trig(s) on the active track.
2. Turn SWING to set the NUDGE value
3. Release the [TRIG] key(s) to exit the NUDGE menu.
9.6 RETRIG SETUP MENU
In this menu you can setup and activate retrigs (additional trigs) that will occur when you play the [T1–6]
pads, or the [TRIG] keys to trigger the track’s sound. The retrigs are recorded as separate trigs. If the retrig
speed is greater than the duration of a sequencer step, trigs are created with additional internal steps (i.e.,
steps with retrig enabled). Each of the six tracks can have its own set of retrig settings. The retrig settings
are stored to the active pattern. Press [FUNC] + [RETRIG] to access the RETRIG SETUP menu. Use LEV-
EL/DATA to change the settings.
RTE Sets the retrig rate (1/1, 1/2, 1/3, 1/4, 1/5, 1/6, 1/8, 1/10, 1/12, 1/16, 1/20, 1/24, 1/32, 1/40, 1/48, 1/64 or
1/80). 1/16 is the nominal retrig rate, one trig per step. 1/32 corresponds to two trigs per step and so on.
To trig triplets, for example, set the retrig rate to 1/12 (or 1/24).
LEN Sets the duration of the retrig velocity curve in fractions of, or rational or integer multiples of, a step
(0,125–INF). 1/16 is the nominal length of one step. This setting aects the behavior of the velocity curve
by defining the boundaries of its envelope.
A.ON Always On sets toggles the retrig function ON/OFF. When on, the retrig activates whenever the
pad of the active track is pressed, and there is no need to press [RETRIG] first.
If you press and hold [RETRIG] and then press a pad, it activates the retrig function and
play back the preset with the current retrig settings.
9.7 TRIG REPEAT MENU
The TRIG REPEAT menu is very similar to the RETRIG SETUP menu. The dierence is that this menu is
used when you want to set up retrig for a specific trig. In GRID RECORDING mode, press and hold one or
several [TRIG] keys and then press [RETRIG] to access the TRIG REPEAT menu. Use LEVEL/DATA to
change the settings. For more information, please see “9.6 RETRIG SETUP MENU” on page 27.
ON/OFF Toggles the retrig function ON/OFF for the chosen trig.
RTE Same as for RETRIG SETUP menu.
LEN Same as for RETRIG SETUP menu.
FAD Sets the velocity curve fade out/fade in of the retrig (128–127). 128 corresponds to a complete
fade out during the set length, 64 fades out to half the velocity during the set length, 0 equals a flat
velocity curve with no fade, 64 fades into half velocity during the set length, and 127 fades in completely
to full velocity during the set length.
While in TRIG REPEAT menu, press [RETRIG] to toggle retrig ON/OFF.