User Manual

APPENDIX B: EFFECTS REFERENCE
123
B.2 12/24DB MULTI MODE FILTER
The resonant 12/24dB lo/hi/band-pass filter gives control of both the low and high filter cutos. Its flexibility
can make it function as a variable gap bandpass filter as well.
MULTI MODE FILTER MAIN
BASE sets the base cuto frequency of the filter.
Sweeping this parameter with WIDTH set to the
max value makes the multi mode filter act as a high
pass filter.
WIDTH controls the distance between the low pass
and high pass cuto frequencies. When BASE is
set to its minimum value, sweeping this parameter
makes the multi mode filter act as a low pass filter.
Q controls the amount of resonance applied to the
cuto frequency or frequencies set in the multi
mode filter SETUP menu.
DEPTH controls how much the filter envelope af-
fects the cuto frequency or frequencies. Negative
values invert the envelope.
ATK sets the attack time of the filter envelope.
DEC sets the decay time of the filter envelope.
MULTI MODE FILTER SETUP
HP sets the high pass filter slope. Select between
12 dB or 24 dB.
LP sets the low pass filter slope. Select between 12
dB or 24 dB.
ENV selects which parameter the filter envelope will
aect.
HOLD controls whether the filter envelope should
be aected by the HOLD parameter of the AMP
MAIN page or not.
Q selects how the resonance will aect the cuto
frequencies. It can aect the BASE, WIDTH, both of
them or none.
DIST sets the headroom of the filter. The higher the
value, the lower the headroom.