User Manual

15. THE MIDI SEQUENCER
92
NOTE sets the root note that should be sent by the MIDI track. When pressing and holding a [TRIG]
key a mini-keyboard will appear in the lower part of the screen. Turning knob A while holding the
[TRIG] key pressed will visualize the root note on the keyboard.
VEL controls the velocity of the notes the MIDI track sends out. A setting of 0 equals a NOTE OFF
command.
LEN sets the duration of the notes. When a note has finished playing a NOTE OFF command will be
sent. A max setting equals infinite note length. This setting also controls the length of an arpeggio.
When the set time has elapsed the arpeggio will be cut o.
NOT2-NOT4 will add more notes, oset from the root note by the selected values, to a note trig. This
makes it possible for a MIDI track to send out chords consisting of up to 4 notes. If the root note is
changed the oset notes will transpose accordingly. When a [TRIG] key is pressed and held the add-
ed notes can be seen on the mini-keyboard. A value of 0 will remove an oset note.
15.4.2 NOTE SETUP
Here the MIDI channel that the MIDI track should send data to is specified. Bank and program change
values are set here as well. When selecting a value in this menu the graphics of the parameter will be-
come inverted. This indicates the parameter value hasn’t been activated yet. Press the corresponding
DATA ENTRY knob or [YES] to activate the parameter change.
CHAN sets the MIDI channel the track will send MIDI data to. When set to OFF the track will not send
data to any MIDI channel.
BANK can be used for sending out a bank change message (MSB). Bank 0 to 127 can be sent. The
maximum parameter value is OFF, (no bank change message sent). The setting made here is sent
every time a pattern linked to another part becomes active.
PROG can be used for sending out a program change message. Program 0 to 127 can be sent. The
maximum parameter value is OFF, which will make the track not send out any program change mes-
sage. The setting made here is sent every time a pattern linked to another part becomes active.
SBNK can be used for sending out a sub-bank change message (LSB). Bank 0 to 127 can be sent.
The maximum parameter value is OFF, (no bank change message sent). The setting made here is sent
every time a pattern linked to another part becomes active.
15.4.3 ARPEGGIATOR MAIN
An arpeggiator is a device that generates rhythmical note progressions.
TRAN is used to transpose the arpeggio up or down in the specified amount of semitones. This set-
ting will aect the note trigs of the track even if the MODE setting is set to OFF.