Element Enduro24 Charge Instructions

Using the provided USB charger with your Enduro 24
Remove the battery from the Enduro 24.
Connect the USB charge lead to the battery connector. Make sure you have the correct
polarity: the red wire at the battery connector should line up with the white wire with gray
dashes on the coating from the charger. See photo.
To battery To charger
Once the battery lead and charge lead are connected, plug the charger into the USB
port on your computer. Or you can plug it into a power brick like those used with your
smart phone.
While charging, the charger light will be red. Once the charge is complete, the light on
the charger will turn off.
Unplug the charge lead from the battery. Be sure to grab it by the connectors and do not
pull using the wires or you may break or damage them.