Use and Care Manual

Table Of Contents

INSTALLATION

Rem

ove all packing material before using your

cooler.

IMP

ORTANT

: Be

fore connecting the unit to a power source, let it stand upright for approximately 24 hours.

This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

This unit is designed for freestanding or built in installation but indoor use only. Position the unit in a dry and

well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct

sun

light. Do NOT install the unit in a location with an ambient temperature that will fall below 41°F.

For built-in installation, leave a 1/4” (6.35mm) space on each side and at the top of the wine

cooler to ensure proper air circulation to cool the compressor and condenser. Also, be sure to not obstruct

the front exhaust vent with any objects as this may affect the unit from performing properly.

For freestanding installation, leave 6” of space at the back, 10-12” of space on each side, and unlimited

clearance at the top of the beverage cooler are suggested to ensure proper air circulation to cool the

compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as this will

not allow for proper air circulation.

Do not slide the unit into place.

Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level the

wine cooler, adjust the front leveling legs at the bottom of the cooler.

For best performance it is recommended that you install the appliance in a location with an ambient

tem

perature between 41-100°F. If the ambient temperature is above or below recommended temperatures,

the performance of the unit may be affected.

Plug the cooler into an exclusive, properly installed-grounded wall outlet.

(The picture is just for reference)

wine