Warranty

LIGHTING INSTRUCTIONS

Using the Ignitor

1. Read instructions before lighting.

2. Burner control knob must be in the “OFF” position.

3. Connect natural gas source (see above pages).

4. Open the natural gas supply to the unit.

5. Push and hold igniter button to create sparks.

6. While holding the igniter button with one hand, use your other hand to push and turn the control knob

to the “LOW” position to light the burner.

7. If ignition does not occur in 5 seconds, push and turn the Control Knob to “OFF”, wait 5 mimutes and

allow gas to dissipate.

8. Once the burner is lit, continue to hold the knob in for another 20 seconds and release.

9. Observe flame, make sure all burner ports are lit. Flame height should be no higher than 13 inches tall.

10. Adjust flame to desired flame with the control knob.

Using a Long Match or Lighter

1. Prior to lighting, use a shovel to move lava rocks for access to

the burner.

2. Wearing heat resistant gloves, position the burning long match

or burning butane lighter near the side of the burner. DO NOT lean

over the fire table while lighting!

3. Turn control knob counterclockwise to “LOW”.

4. Remove long match/long butane lighter.

5.After lighting, use a shovel and heat resistant gloves to carefully

move the lava rocks back into their proper position.

6. Observe flame, make sure all burner ports are lit. Flame height

should be no higher than 13 inches tall.

7. Adjust the flame to the desired height with the control knob.

Keep the lava rock covered and make sure it is dry before igniting.

When using this method to light your fire table, use heat resistant gloves and follow the step by

step instructions.Failure to do so could result in severe injury.

WARNING

If burner fame goes out during operation, immediately turn the control knob “OFF” and let the gas

clear a minimum of 5 minutes before attempting to re-light the fire table.

TURNING OFF

1.Push and turn the control knob clockwise to the “OFF”position.

2.Shut off gas supply at the shut-off valve and disconnect the quick disconnect socket from the main

gas supply.

LOW

(BAS)

HIGH

(HAUT)

OFF(ARRET)

13 / 40