Use and Care Manual

ASSEMBLY INSTRUCTIONS
PARTS LIST
1. Carefully remove all four glass panels from the packaging and lay them out on a flat surface with a
blanket or some sort of cloth to prevent scratching.
2. Next remove the 8 corner brackets. Make sure each bracket has 2 screws per bracket.
3. Loosen the set screws on each of the 8 brackets to allow for easy installation of the glass panels.
4. Slide the bracket onto one glass panel and stand the glass panel vertical (as it will sit once fully
assembled). This position allows the brackets to be tightened properly so the glass guard will sit evenly
around the burner pan lip and lay completely flat.
5. Tighten the set screw onto the glass panel until it is firmly in place. DO NOT tighten the set screw too
tight, as the glass will crack. Only hand tighten with a flat head screwdrivers. DO NOT tighten with an
electric or battery operated power screwdriver.
6. Once you have fastened the bottom brackets on one panel,
continue adding panels and connecting the bottom brackets on
each panel until all four panels are connected.
7. After all of the bottom brackets have been added, add the
top brackets on each glass panel making sure that each one
is tightened completely.
8. Upon assembling all eight brackets onto the wind screen,
set the complete apparatus over the burner pan. Make sure it
lays flush to the burner pan or fire table top. If needed loosen
and re-tighten bracket set screws until the wind screen sits flat.
Ocean Rock USA INC
692 Parkridge Ave Norco, CA 92860, USA
www.elementifire.com
[e-mail]
Tel: [phone]
X 4 pcs
X 4 pcs
Top Brackets
Screw
Bottom Brackets
Screw
Rubber Pad
Top Brackets
Bottom
Brackets
Rubber Pads were
attached on the
bottom.
Wind Screen Glass Panel
X 4 pcs