Manual

ManualsBrandsElementi ManualsFire PitsOFG201-NG Workshop Dining Table with Electronic Ignition with Auto Safety Shut-Off, 45000 BTU per hour, in Cast Concrete

IMPORTANT WARNING

WARNING

DANGER

INSTALLER:

Leave this manual with the appliance.

CONSUMER:

Retain this manual for future reference.

For outdoor use only

Installation and service must be

performed by a qualified installer,

service agency, or the gas supplier.

FIRE OR EXPLOSION HAZARD

If you smell gas:

• Shut off gas to the appliance.

• Extinguish any open flame.

• If odor continues, leave the area immediately.

• After leaving the area, call your gas supplier or fire department.

Failure to follow these instructions could result in fire or explosion,

which could cause property damage, personal injury, or death.

• If the information in this manual is not followed exactly,

a fire or explosion may result causing property damage

personal injury or loss of life.

•

Read the installation, operation

and maintenance instructions

thoroughly before installing or

servicing this equipment.

• Save these instructions for

future reference. If you are

assembling this unit for someone

else, give this manual to him or her

to read and savefor future

reference.

Do not store or use gasoline or other

flammable vapors and liquids, in the

vicinity of this or any other appliance.

This unit is not for use with propane.

Use only with Natural gas.

WARNING

• Installation and service must be

performed by a qualified installer,

service agency or gas supplier.

• Improper Installation, adjustment,

alteration, service or maintenance

can cause injury or property

damage.

Manual No.: ANGE12EN-G201-A5

ELEMENTI

THE ART OF FIRE

Sonoma Dining Table

OFG201NG

Owner's Manual

Gas type: Natural Gas

Summary of content (20 pages)

PAGE 1
Manual No.: ANGE12EN-G201-A5 ELEMENTI THE ART OF FIRE OFG201NG Sonoma Dining Table !! IMPORTANT INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference. ! WARNING Do not store or use gasoline or other flammable vapors and liquids, in the vicinity of this or any other appliance. This unit is not for use with propane. Use only with Natural gas.
PAGE 2
TABLE OF CONTENTS Important Safety Information -----------------------------------------------------------------------3 Natural Gas Warnings -------------------------------------------------------------------------------5 Parts List ------------------------------------------------------------------------------------------------7 Pre-use Instructions ---------------------------------------------------------------------------------12 Lighting Instructions ------------------------------------------------------
PAGE 3
IMPORTANT SAFETY INFORMATION ! WARNING FIRE TABLE IS FOR OUTDOOR USE ONLY IF YOU SMELL GAS • Shut off gas supply to the fire table. • Extinguish any open fame. • Do not try lighting any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. • Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department.
PAGE 4
IMPORTANT SAFETY INFORMATION • DO NOT use this outdoor gas fire table for indoor heating. Toxic carbon monoxide fumes can accumulate and cause asphyxiation. • NEVER leave this gas fire pit unattended when in use. • Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. • DO NOT store or use gasoline or other flammable vapors and liquids within 25 feet (7.62m) ofthis or any other appliance.
PAGE 5
IMPORTANT SAFETY INFORMATION • It is essential to keep the outdoor fire table valve compartment, burners, and circulating air passages clean. Inspect outdoor fire table before each use. • Prior to each fire table operation, check the hose for evidence of excessive abrasion or wear by looking through the visual check hole. If the hose is damaged,cracked or cut, it must be replaced before using the gas fire table. The hose assembly can only be replaced with a hose assembly specified by the manufacturer.
PAGE 6
NATURAL GAS DANGERS AND WARNINGS • Never store or use gasoline or other volatile substance in the vicinity of this fire table. Natural Gas Connection Connect a manual shut-off valve to gas supply line. Apply sealing compound or pipe thread tape of the type resistant to the action of natural gas on all male pipe threads. Connect the end, with the quick release connector, or the natural gas hose to manual shut-off valve at the gas supply.
PAGE 7
PARTS LIST Item Picture Description Qty. 01 Burner 1 pc 02 Guard 1 pc 03 Fixed block 4 pcs 04 Air inlet pipe A 1 pc 05 Air inlet pipe C 1 pc ! WARNING For technical support or replacement parts or missing parts please contact Elementi at 800-678-7294.
PAGE 8
ASSEMBLY INSTRUCTIONS Install the AAA battery as shown in the diagram below. Battery not included. 1 _ + Place lava rock by hand. DO NOT dump bag out in to the tray to avoid clogging the burner with dust. Position the lava rock to a level about 1” above the t op of the burner. Make sure that you do not block the igniter box with lava rock to ensure proper ignition.
PAGE 9
ASSEMBLY INSTRUCTIONS Adjustable feet has pre-installed on the bottom of fire pit already. Please adjust the hight of feet to make sure all fire pit was on level always, or increase the height of fire table as your preference. Please make sure the height was safty before you complete. FIREPIT 3 FIREPIT Connecting your Fire Table to the Natural Gas Source A professionally installed shut-off valve between the supply piping and the socket is recommended by the National Fuel Gas Code.
PAGE 10
ASSEMBLY INSTRUCTIONS 4 Connecting the Socket Coat the gas supply pipe nipple with gas resistant pipe compound or approved Teflon PTFE tape. Screw socket onto gas supply pipe (house gas source) as shown to the right, and wrench tighten. The quick disconnect socket should never be connected to the fire table. Direction of gas flow is indicated on the socket.
PAGE 11
ASSEMBLY INSTRUCTIONS Using the Quick Connect Socket Pull back the sleeve on the quick disconnect socket and insert the unattached end of the gas hose into the socket. Release the sleeve and continue pushing the hose into the socket until the sleeve snaps into the locked position. After making all connections, perform a leak test as described on page 12 of this manual.
PAGE 12
PRE-USE INSTRUCTIONS ! WARNING Before using this outdoor fire table, make sure you have read, understand and are following all information provided in the Important Safety Information section of this manual. Failure to follow those instructions can cause death, serious injury or property damage. Prior to each gas fireplace operation, check the hose and valve for evidence of excessive abrasion or wear though the visual check hole on the side of the base.
PAGE 13
LIGHTING INSTRUCTIONS Using the Ignitor 1. Read instructions before lighting. 2. Burner control knob must be in the “OFF” position. 3. Connect natural gas source (see above pages). 4. Open the natural gas supply to the unit. 5. Push and hold igniter but t urn to create sparks. 6. While holding the igniter button with one hand, use your other hand to push and turn the control knob to the “LOW” position to light the burner. 7.
PAGE 14
CARE AND CLEANING Inspecting This outdoor fire table must be inspected regularly to insure that the product is safe to use and to extend product life. ! WARNING DO NOT inspect this outdoor fireplace until the fire is COMPLETELY out. 1. Check the burner to make sure it is securely in place. 2. Check all gas connections for leaks. 3. Check ignition system to insure proper sparking. 4. Check components for any signs of damage, rust or excessive wear. 5.
PAGE 15
CARE AND CLEANING Please see below for recommendations on maintaining your fireplace surface for years of extended use: • Clean any spills immediately to prevent permanent surface(s) staining or damage to your fireplace. • Blot any liquid spills with a clean, dry cloth to avoid spreading of the spill to the rest of the fireplace.
PAGE 16
GAS COMPONENT CONNECTION CHECKS 2. Make sure that the pilot housing is unobstructed. Clear any debris on top of the pilot housing and make sure there is no debris between the igniter pin, thermocouple and the burner tube. CORRECT INCORRECT 5mm / 0.196” Thermocouple Igniter Pin 3. Make sure that the igniter pin and thermocouple are correctly positioned. - The igniter pin should be pointed straight to the thermocouple. - The thermocouple should be positioned 5mm / 0.196” away from the burner tube.
PAGE 17
TROUBLESHOOTING Problem: Burner will not light using igniter Possible Cause 1: Electrode and burners are wet. -Wipe dry with cloth. Possible Cause 2: Igniter battery is dead or backwards. -Check that the AAA battery is inserted correctly in the igniter (see page 8) or replace the battery. Possible Cause 3: Igniter Pin cracked or broken - sparks at crack. -Call ELEMENTI at 800-678-7294 for technical support. Possible Cause 4: Wire loose or disconnected. -Reference page 15, step 1, reconnect wire.
PAGE 18
TROUBLESHOOTING Problem: Sudden drop in gas flow, or a reduced flame height Possible Cause 1: Out of gas. -Call your local gas company. Possible Cause 2: Excess flow safety device may have been activated. -Turn control knob to “OFF”, wait 30 seconds and light outdoor fire table. If flames are still too low reset the excessive flow safety device by turning off the control knob and the gas supply. Disconnect the quick disconnect socket. Turn Burner Control Knob to "HIGH". Wait 1 minute.
PAGE 19
Warranty Ocean Rock USA INC. doing business as Elementi, warrants Elementi fire features and accessories to be free from defects in parts and workmanship under normal use and service for a period of 1 year from the date of purchase. In the event of such defects Elementi will, at its option, repair or replace the defective product. The foregoing is at the discretion of Elementi.
PAGE 20
ELEMENTI THE ART OF FIRE Ocean Rock USA INC. 692 Parkridge Ave Norco, CA 92860, USA www.elementifire.com info@elementifire.