Instruction manual

3. B Parts: Assemble B1 as shown in Figure Ba. Note
that the tabs on A3 and A9 must be pointed as shown.
Press down A9 and then hold B1 on top of it. The two
holes in B1 fit around two tabs (one round, one
rectangle) and can slide along them. Place B2 on top
of B1, snapping it in as shown in Figure Bb. Both B1
and B2 should now be laying flat. Assemble A10, B3
and G3 as shown in Figure Bc (these, or a similar
mechanism, may have come already installed on B2).
Be sure you install B2 with B3 positioned in G1 as
shown. Install the G2 screws IN THE ORDER SHOWN
and BE SURE THEY ARE TIGHT or the film-advance
mechanism may not work. The third screw shown is not
needed in most models, you should install it only if it
extends into something besides B2. You may use the
screwdriver included with this kit or your own.
Before installing spring B4, you should do a quick test.
Turn A9 (the film advance knob) to the right (it won’t go
the other way) until it stops. (If it is already stopped, you
can release it by pulling B1 to the right using the tab
that B4 will attach to). The tab on A3, sticking up
through B2, should be pointed away from the film
counter (part of B2). If this is correct then install B4 and
continue with step 4; if this is wrong, remove B1 and B2
and re-orient the tabs on A3 and A9 because your film
counter reset may not work.
Now install B4 as shown in Figure Bc.
-8-
Tabs on A3
& A9 must
be pointed
as shown
B1
Figure Ba
B2
G2Install this screw first.
Must be tight.
Install this
screw second.
May not be
needed, install only
if it extends beyond
B2 into something.
Figure Bb
Bent side of A10 goes around the post as shown.
A10
A10, B3 and
G3 may be
pre-installed
G3
B3
*
*
B4
Figure Bc
Straight side of
A10 goes
behind the post
as shown.
Slide the tab of B3 into
the slot of G1 shown
here.