Instruction manual

FINAL ASSEMBLY
Figure 9
Figure 11 Figure 12
Note: Be sure that you place the battery holder at the bottom of the back cover as shown
in Figure 14. Also, make sure that the three positive (+) battery terminals are pushed up
against the battery holder contacts.
Insert
Foil Side of
PC Board
Push in until
it snaps.
Wire from (–)
Wire from (+)
Legend Side
of PC Board
Solder the wires from
the (+) and (–) points
on the PC board to
the flash tube (see
Figure 12).
2
4
Assemble the PC
board, switch and pot
to the front panel as
shown.
3
1
Figure 10
Figure 13
Figure 14
Remove the backing on both sides
of the double-sided tape and apply
it to the back of the battery holder.
Now, place the battery holder
inside of the case as shown in
Figure 14.
Insert three “AA” size (alkaline
only) batteries into the battery
holder.
T2 (See Figure 9) -
Insert the flash tube
assembly and solder T2 to
the PC board as shown in
Figures 10-12.
2-56 Nut
Lockwasher
2-56 x 5/8” Screw
2 x 0.4 x 5mm Screws
8mm Flat Washer
7mm Hex Nut
5/16” Lockwasher
Battery Holder
Double-sided
Tape
Back Cover
Front Cover
Top
-8-