Manual

Assembly:
1. Place base grid supports on base grid B.
2. Place parts on grid A, and install into base grid supports on
grid B. Note that the pairs of red pieces marked “V1’ on both
grids are the same parts (vertical snap wires), mounted in
different dimensions.
3. Install remaining parts on grid B.
4. Place the projector on the white LED (D6), with the red knob
facing up.
Place the circuit in a dark room and point it towards a wall, white
walls give best effects. Turn on the slide switch (S1) and turn
the knob on the projector to show the 6 images on the wall. The
room should be very dark for best effects. You can also get good
results by projecting the images on a white box a few feet away.
Project 51
Wall Projector
Project 50 Wall Light Show
Use two vertical snap wires (V1) and mount the
color LED (D8) on them so it will shine towards a
wall, then place the lined lens on the color LED.
Place the circuit in a dark room and point it towards
a wall, white walls give best effects. Turn on the
slide switch (S1) and rotate the clear part of the
lined lens to see how the light show changes. The
room should be very dark for best effects. You can
also get good results by projecting the light on a
white box a few feet away.
-47-
LINED
LENS