Data Sheet

Project 33 Any Angle LEDs
Assembly (adult supervision recommended):
1. Place base grid supports on base grid A.
2. Mount parts on grids B & C, and install in base grid supports in
grid A. The pegs should be facing inward.
3. Place remaining parts on grid A.
4. Mount the blue & color2 LEDs (D9 & D12) to the 3D snaps,
connect 1-snap wires on both sides, and attach to the parts on grids
B & C, as shown. The “+” side of the LEDs should be towards grid C.
Turn on the slide switch (S1). The color2 and blue LEDs light; rotate
them to any position. The circuit looks best in a dimly lit room.
Use the preceding circuit but
replace the blue or color2 LEDs
with the blink red LED (D11),
lamp (L4), or melody IC (U32
“+”
on right ). You may also remove
one of the lights.
Project 34
Any Angle LEDs
Variants
-26-
Note: If the LED
assembly fit seems tight,
remove this 1-snap wire.
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:30 PM Page 27