Data Sheet

Project 35 Super Spinning Magnet
Assembly:
1. Place base grid supports on base grid A.
2. Mount parts on grid B (except the blue jumper wire),
and install in base grid supports in grid A. The pegs should
be facing inward.
3. Place remaining parts on grid A, including the blue
jumper wire. Note that the color LED (D12) and lamp (L4)
are mounted on the 3D snaps, which are then mounted on
the 90 degree vertical snap wires (V1).
4. Place the gear insert on the shaft of the orange motor
(M9) and place the magnet on it, centered so it balances.
Turn on the slide switch (S1). The color2 LED (D12) and
lamp (L4) light; rotate their position as
desired. The orange motor spins the magnet, and the blue
LED (D9) lights when the reed switch (S9) is triggered by
the magnet.
If desired, swap the locations of the LEDs and lamp, or
replace one with the blink red LED (D11).
Note: if the LED assembly fit seems loose, add a 1-snap
wire between one of the 3D snaps and a V1.
-27-
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:30 PM Page 28