Data Sheet

Project 42
Disco Effects (II)
Assembly (adult supervision recommended):
1. Place base grid supports on base grid A.
2. Place parts on base grids B, & D, and install into base grid
supports on grid A. The pegs should be facing inward.
3. Mount grid C on top of grids B & D using 4 stabilizers,
attaching the 2 vertical snap wires (V1) as you do it.
\
4. Place the remaining parts on grids A & C. Note that grid C is
upside down, so place the parts on it carefully. The mirror ball
is placed on the orange motor (M9).
Turn on the slide switch (S1) to spin the mirror ball and light the
LEDs (D9, D11, and D12). Take the circuit into a dark room for
best effects.
-34-
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:30 PM Page 35