Data Sheet

Assembly (adult supervision highly recommended):
1. Place base grid supports on base grid A.
2. Place parts on base grids B & C, and install into base grid supports on
grid A. The pegs should be facing inward. Do not use the double-sided
grid.
3. Place remaining parts on grid A.
4. Mount grids D & E, at the angles shown and with pegs facing down,
on top of grids B & C using 6 stabilizers, and attaching the 45 degree
vertical snap wires (V2) from grids B & C and adding one 90 degree
vertical snap wire (V1) as you do it. Note that grid D should be the
double-sided grid. Adjust the positions of the stabilizers as needed.
5. Add the remaining parts on grids D & E.
Turn on the slide switch (S1) to light the lamp (L4).
Underside
view
-40-
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:31 PM Page 41