Data Sheet

-42-
Project 52 House with Doorbell
Assembly:
1. Place parts on grid B, including the base grid support, 90 degree vertical
snap wires (V1), and press switch (S2). Note that grid B is the two-sided
grid, and the press switch is on the reverse side. Install grid B on grid A.
2. Place remaining parts on grid A.
3. Install grids C, D, & E into base grid supports on grid A, and secure with
4 stabilizers.
Push the press switch to ring the doorbell. It sounds best if you press it for
a few seconds.
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:31 PM Page 43