Data Sheet

-44-
Assembly (adult supervision highly recommended):
1. Place base grid supports on base grid A.
2. Mount parts on grids B and install in base grid supports in grid A. The
pegs should be facing inward. Do not use the double-sided grid.
3. Place remaining parts on grid A.
4. Mount grids D & E at the angles shown and with pegs facing down, on
top of grids
B & C using six stabilizers, attaching the two angled snap wires (V2) and
two 90 degree vertical snap wires (V1) as you do it. Note that grid D is the
double-sided grid. Adjust the positions of the stabilizers as needed.
5. Add the remaining parts on grid D.
Turn on the slide switch (S1). The clear motor (M4) spins a ceiling fan, the
melody IC (U32) plays a tune, and the lamp (L4) lights. This circuit looks
best in a dark room.
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:31 PM Page 45