Data Sheet

-49-
Project 58 Disco Lights
Build the circuit as shown; it has the blue LED (D9) and
color2 LED (D12) each mounted on two vertical snap
wires (V1). Place the mirror ball on the orange motor (M9).
Turn on the slide switch (S1. Place the circuit in a dark
room, so that light from the blue and color2 LEDs reflects
off the mirror ball to the walls and ceiling. The press and
reed switches (S2 & S9) are used only for mechanical
support, and not electrically connected.
Project 59
Angled Disco Projector
Build the circuit as shown; it has the blue LED (D9) mounted on two 45
degree vertical snap wires (V2). Place the mirror ball on the orange
motor (M9).
Turn on the slide switch (S1) and place the circuit in a dark room, so
that light from the blue LED reflects off the mirror ball to a nearby wall
and ceiling.
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:31 PM Page 50