Data Sheet

Project 60
Both Sides Lights
Assembly:
1. Place base grid supports on base grid A.
2. Place parts base grids B, then install grid
B into base grid supports on grid Grid B
must be the two-sided grid.
3. Place the remaining parts on grid A.
Turn on the slide switch (S1) to light the
LEDs (D9, D11, & D12) and lamp (L4), and
play a melody.
Project 61
Quiet Both Sides Lights
Use the preceding circuit, but remove the
melody IC (U32). You can also re-arrange
the lights.
Project 62
Spinning Magnet
Build the circuit, place the gear
insert on the orange motor (M9),
then lay the magnet so it is
centered on the gear insert. Turn
on the slide switch (S1). The
orange motor slowly spins the
magnet, activating the blue LED
(D9) as the magnet passes over
the reed switch (S9).
-50-
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:32 PM Page 51