Data Sheet

Project 63 Disco Spotlight
Assembly:
1. Place base grid supports on base
grid A.
2. Place parts base grids B, then
install grid B into base grid
supports on grid A. Note that the
blue LED (D9) is mounted on the
45 degree vertical snap wires
(V2) so it can shine over grid A.
3. Place the remaining parts on grid
A. Mount the mirror ball on the
orange motor (M9).
Turn on the slide switch (S1). The
orange motor spins the mirror ball,
and the blue LED shines on it. Place
the circuit in a dark room to see
disco lights on the walls and ceiling.
The reed switch is used here only for
mechanical support, so do not
activate it.
Project 64 Spotlight
Use the preceding circuit, but replace the
blue LED(D9) with the color2 LED (D12),
blink red LED (D11), or the lamp (L4). You
can also replace the orange motor (M9) and
mirror ball with the clear motor (M4) and
wind fan.
Project 65 Spin the Magnet
Build the circuit, with the wind fan
mounted on the clear motor (M4).
Lay the magnet on the fan and
slowly spin the fan with your
finger, keeping the magnet on the
fan. The blue LED (D9) should
turn on and off as the magnet
moves over the reed switch (S9).
-51-
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:32 PM Page 52