Data Sheet

Use Project 84 circuit, but remove the
string and 45 degree vertical snap wire
(V2). Replace with the Illusion card
holder with the fan. Turn on the slide
switch (S1); when the magnet passes
the reed switch (S9) the fan spins and
then turns off. The color2 LED (D12) will
not flash since the motor does not turn
backwards.
Project 86
Magnet Fan
Use the preceding circuit, but place the
blue jumper wire across the red LED
(D11). Turn on the slide switch (S1); the
fan spins more often since the gear
spins faster.
You can also swap the blue & red LEDs
(D9 & D11) to make the lights different.
Project 87
Fast Magnet Fan
Project 88 45° LEDs
Place all the parts on the base grid,
then install the blue LED (D9) and
color LED (D12) on the 45 degree
snap wires (V2). Turn on the slide
switch (S1); both LEDs should light.
Project 85
Fast Lifter
Place a blue jumper wire across the
red LED (D11). Turn on the slide
switch (S1); the 4
5 degree vertical
snap wire (V2) rises and falls more
often since the gear spins faster.
You can also swap the blue & red
LEDs (D9 & D11) to make the lights
different.
Project 89 Pivot LED Bar
-61-
Place the parts on the base grid, then
assemble the parts on the vertical snap
wires (V1).
Push the press switch (S2) on; the LEDs and
lamp turn on. The LEDs pivots around the
top snap of vertical snap wires; move the
LEDs to different positions,
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:32 PM Page 62