Data Sheet

Project 125
Mini Plane
Place the parts on the base grid then assemble the parts on the four
90 degree vertical snap wires (V1).
Be sure to hold the “plane” so that the green fan does not touch the
base grid.Turn the slide switch (S1) on; the mini plane is flying with a
flashing tail light. Rotate the body to simulating flying up or down. if
desired, place the egg LED attachment on the blue LED (D9).
Use the preceding circuit, but replace the blue LED (D9) with the melody
IC (U32) and replace the blink red LED (D11) with the lamp (L4). Turn
the switch on; the mini plane now has sound and a white light.
Project 126
Music Mini Plane
-74-
Note: If the LED
assembly fit seems
loose add a 1-snap
wire between one of
the 3D snaps and a V1.
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:33 PM Page 75