Data Sheet

-81-
Project 144
Showcase
Assembly:
1. Place base grid supports on base grid A.
2. Place parts on grids B & C, then install into base grid supports on grid
A. The pegs must be pointed inward.
3. Install remaining parts on grid A. Place the gear insert on the orange
motor (M9), flat side up.
4. Install the blue LED (D9) on the two vertical snap wires (V1) that hang
over the orange motor.
Place any object you want to showcase the on the orange motor. Turn
on the slide switch (S1); the orange gear slowly spins the “showcase
object”, and the LED shines on it. Dim the room lights for best effects.
You can replace the blue LED with the color2 LED (D12).
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:34 PM Page 82