Data Sheet

-87-
Project 154
Strobe
Assembly :
1. Place the base grid supports on base grid A.
2. Place parts on grid B, then install grid B on base grid supports on grid
A. The pegs must be pointed inward.
3. Place remaining parts on grid A, and connect the blue jumper wire.
4. Assemble the paper magnet holder as shown.
Turn on the slide switch (S1). The lamp (L4) flashes as the magnet passes
the reed switch (S9).
1. Cut a 3” x 3” piece of paper and fold in half
2. Place magnet in center and fold in half.
3. Fold in bottom section up as shown.
4. Insert ensemble into the Illusion card holder.
3 x 3
3” x 1.5”
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:34 PM Page 88