Data Sheet

-89-
Project 157
Tower
Assembly (adult supervision recommended):
1. Place the base grid supports on base grid A.
2. Place parts on grid B (except the jumper wires) and install into base grid supports on grid A.
Note that two snap wires hang off the top of grid B.
3. Install remaining parts on grid A and connect the red & black jumper wires.
4. Install grid C onto grid B using 2 stabilizers and connecting the snap wires between them.
5. Place the remaining parts on grid C. Note that two snap wires hang off the top.
6. Install grid D onto grid C using 2 stabilizers and connecting the snap wires between them.
7. Place the remaining parts on grid D. Check everything to make sure the structure is stable.
Turn on the slide switch (S1). The LEDs light and a fan spins.
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:34 PM Page 90