Data Sheet

Project B5 Bonus House with Loft
-95-
Requires parts from modelSC-3Di.
Turn on the slide switch (S1). If the clear motor (M4) is not spinning
then push the press switch (S2) to get it started. Completely cover
the color LED (D8) to block all its light. Place the circuit in a dark
room and watch as light from the color2 LED (D12) is reflected
onto the walls.
You can swap the locations of the color and color2 LEDs to change
the effects, or replace either the LEDs with different ones.
Project B4 Bonus Reflection Light
THISPROJECT REQUIRESPARTSFROMMODELSC-3Di.
Assembly (adult supervision highly recommended):
1. Place base grid supports on base grids A & B. Note
that grid F will be the 2-sided grid.
2. Place parts on base grids C, D & E, and install into
base grid supports on grid A, connecting the two vertical
snap wires (V1) between the grids as you do it. Grids C
& E are full size grids. The pegs should be facing inward.
3. Place parts on both sides of grid F, and install on grids
C & E using 2 stabilizers. The orange motor (M9) should
be on the top side.
4. Place remaining parts on grid A.
5. Attach grids G & H to each other using 2 vertical snap
wires and 2 stabilizers.
6. Mount grids G & H, at 45 degree angles and with pegs
facing downward, on top of grids C & D using 4
stabilizers, attaching the two 45 degree vertical snap
wires (V2) on grids C & D as you do it. Adjust the
positions of the stabilizers as needed.
7. Carefully place the remaining parts on grids G & H.
8. Carefully place the wind fan on the clear motor (M4),
the mirror ball on the orange motor, and the fiber optic
festive tree (with its mounting base) on the color2 LED
(D12) if you did not do so earlier.
Turn on the slide switch (S1) and enjoy the show! For
best effects place the circuit in a dimly lit room.
SC-3DMEG_Manual.qxp_SC-3Di_Manual_060816 6/19/17 7:34 PM Page 96