Manual Part 2

42
Assembly (adult supervision recommended):
1. Place base grid supports on base grid A & B.
2. Place parts (except for the jumper wires) on base grids C
& D, and install into base grid supports on grids A & B. The pegs
should be facing inward for grid C and outward for grid D.
3. Place remaining parts on grids A & B.
4. Place parts on grid E, and mount grid E onto grids C & D using
4 stabilizers, connecting to the vertical snap wires (V1) on grid C
as you do this. Adjust the positions of the stabilizers as needed.
Attach all jumper wires if you have not done so already.
5. Mount grids F & G, at 45 degree angles and with pegs oriented
down, on top of grids C & D using 6 stabilizers. Adjust the
positions of the stabilizers as needed.
Turn on the slide switch (S1). The lamp (L4), motor (M4), and
color LED (D8) should be on. Push the press switch (S2) to hear
a doorbell (from the melody IC (32)). The white LED (D6) is bright
if room is dark, and gets dim as you shine light on phototransistor
(Q4); shine a bright light on Q4 to turn off D6. If desired, place the
light covers with a slide on any of the LEDs or the lamp. Do not
leave the circuit for two minutes because the lamp will be hot.
The light covers and slides may be placed on the LEDs (D6 and
D8) or lamp (L4) as decoration. Fold the slides as indicated and
slide them into the slots on the cover, as shown.
Running a ceiling fan will allow you to raise the air conditioner setting in the room about 4°F with no reduction in comfort.