Manual Part 2

Assembly (adult supervision recommended):

1. Place base grid supports on base grids A & D.

2. Place parts (except for the jumper wires) on base grid B, and

install grids B & C into base grid supports on grid A. The pegs

should be facing inward on grids B and C.

3. Place parts (except for the jumper wires) on base grid E, and

install grids E & F into base grid supports on grid D. The pegs

should be facing inward on grids E and F.

4. Place remaining parts on grids A & D.

5. Mount grids D-E-F assembly on grids B & C using 4 stabilizers,

as shown. Adjust the positions of the stabilizers as needed.

6. Mount grid G on grids E & F using 4 stabilizers, as shown. The

pegs on grid G should be facing down. Adjust the positions of the

stabilizers as needed.

7. Connect the blue and black jumper wires as shown.

Set the meter (M6) to the 5V scale and turn on the slide switch

(S1). The lamp (L4) and LEDs (D6 & D8) light, the melody

IC plays a tune, the motor (M4) spins the fan, and the meter

measures the battery voltage. You can place a slide on one of

the light covers and place it on the color LED or lamp. The LEDs,

lamp, and melody IC can be re-arranged as desired. Do not leave

the circuit for two minutes because the lamp will be hot.

The light covers and slides may be placed on the LEDs (D6 and

D8) or lamp (L4) as decoration. Fold the slides as indicated and

slide them into the slots on the cover, as shown.