Manual Part 2

53
Fiber Optic Festive
Tree
The ber optic festive tree can be mounted on the
LEDs (D6 and D8) to enhance their light effects.
The ber optic festive tree must be mounted
using the mounting base, as shown.
The light covers and slides may be placed on the
LEDs (D6 and D8) or lamp (L4) as decoration.
Fold the slides as indicated and slide them into
the slots on the cover, as shown.
● Use only 1.5V AA type, alkaline batteries
(not included).
● Insert batteries with correct polarity.
● Non-rechargeable batteries should not be
recharged. Rechargeable batteries should
only be charged under adult supervision,
and should not be recharged while in the
product.
● Do not connect batteries or battery holders
in parallel.
● Do not mix old and new batteries.
● Do not mix alkaline, standard (carbon-zinc),
or rechargeable batteries.
● Remove batteries when they are used up.
● Do not short circuit the battery terminals.
● Never throw batteries in a re or attempt to
open its outer casing.
● Batteries are harmful if swallowed, so keep
away from small children.
● When installing a battery, be sure the spring
is compressed straight back, and not bent
up, down, or to one side.
● Battery installation should be supervised by
an adult.
Batteries:
The clear motor (M4) will often have the wind fan
mounted on it; simply push the fan onto the shaft.
To remove it, push up on it with a screwdriver or
your thumbs, being careful not to break it.
HOW TO USE YOUR SNAP CIRCUITS
®
Note: while building
the projects, be careful
not to accidentally
make a direct
connection across
the battery holder (a
“short circuit”), as this
may damage and/or
quickly drain
the batteries.