User's Manual

USA/CA-7

Combio-915 RM

USA/CA-8

Combio-915 RM for tubular motors (28 520.0001)

The Combio-915 is suitable for the use with tubular motors for

roller shutters and sun protection systems.

If a command is sent, the receiver immediately activates the self-

locking operating mode.

The hand-held transmitter can be used to program an intermediate

position.

For sun protection systems it is possible to additionally program a

fabric tautening and a ventilation position for roller shutters

(D refer to the transmitter instructions).

Combio-915

Drive

Antenna

Mains

230 V/50 Hz

Note: Do not shorten or lengthen the antenna.

Pin Wire colour

designation

L Brown

N Blue

PE Green/yellow

Connection and installation (Combio-915 JA)

Combio-915 JA for venetian blind drives

1. Put the drive into operation with the installation cable and

set the upper and lower limit switch.

2. Move the hangings with the installation cable to an

intermediate position.

3. Switch off the mains voltage.

4. Unplug the installation cable.

5. Connect the female Hirschmann-plug of the radio receiver

with the drive plug.

6. Connect the Hirschmann-plug of the radio receiver with the

female plug of the mains cable.

Combio-915

123

Antenna

Mains

230 V/50 Hz

7. Fasten the radio receiver.

8. Switch the mains voltage on again.

9. Programme the transmitter

(D refer to the transmitter instructions).

USA