User's Manual

USA/CA-9
Connection and installation (Combio-915 RM)
USA/CA-10
The Combio-915 RM for elero tubular motors with plug-in
cable (limit switch drive)
1. Switch off the mains voltage.
2. Press the locking mechanism of the drive plug towards the
cable with a screwdriver.
3. Pull out the plug.
4. Plug the motor cable of the radio receiver into the drive.
5. Connect the mains cable of the Combio-915 RM correctly with
the mains voltage.
RM
Combio-915
PE
L
N
Antenna
1~
M
Mains
230 V/50 Hz
6. Fasten the radio receiver.
7. Switch the mains voltage on again.
8. Programme the transmitter (D refer to the transmitter
instructions).
9. Mount the hangings and set the limit switch.
Pin Wire colour
designation
L Brown
N Blue
PE Green/yellow
Connection and installation (Combio-915
Combio-915 RM for tubular motors with plug-in cable
(ACS-E electronic drive)
1. Switch off the mains voltage.
2. Press the locking mechanism of the drive plug towards the
cable with a screwdriver.
3. Pull out the plug.
4. Plug the motor cable of the radio receiver into the drive.
5. Connect the mains cable of the Combio-915 RM correctly with
the mains voltage.
RM
Combio-915
PE
L
N
Antenna
1~
M
Mains
230 V/50 Hz
6. Fasten the radio receiver.
7. Switch the mains voltage on again.
8. Programme the transmitter (D refer to the transmitter
instructions).
Note: Rotate the winding shaft manually in the corresponding
direction.
9. Mount the hangings and operate the drive in the self-program-
ming mode.
Pin Wire colour
designation
L Brown
N Blue
PE Green/yellow
USA
CA