elero LumeroTel-915 USA Operating instructions Please keep these instructions in a safe place! GB Operating Instructions Please keep the instructions in a safe place. FR Notice de service Prière de conserver cette notice de service ! ES Manual de instrucciones ¡Por favor guarde estas instrucciones! IT Istruzioni per l'uso Conservare le istruzioni! PL Instrukcja obs∏ugi Instrukcj´ nale˝y zachowaç ! elero USA 10827 Alder Circle USA-Dallas Texas 75238 info@eleroUSA.
Contents USA-1 USAUSAUSAUSAUSAUSAUSAUSAUSAUSAUSAUSAUSAUSA- 2 3 4 5 5 6 6 7 7 7 7 8 8 8 USA-10 USA-10 USA-10 USA- 11 USA- 11 USA- 11 USA- 11 USA-12 USA-12 USA-12 USA- 13 USA- 13 USA- 13 USA- 13 USA- 13 USA Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Instruction to the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Explanation of buttons . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Installation General information Note: The LumeroTel-915 handheld transmitter can be used to operate one or more receivers. This device is characterised by its user-friendly operation. USA General information/Designated use Radio base stations transmitting in the same frequency range may cause reception interference. Please note that the operating range of the radio signal is limited by legislation as well as by the product design.
Programming radio channel settings Manual/Automatic sliding switch Programming transmitter/channel The sliding switch is used to switch the receivers into either manual or automatic mode. When the sliding switch is set to automatic mode, the receivers will respond to every signal transmitted, whereas in manual mode they will only respond to UP, STOP and DOWN control commands, as well as to wind alarm signals. Prerequisite: The receiver must be installed. 1.
Intermediate position for roller shutter/awning/venetian blind USA Programming radio channel settings Note: If more than one receiver is connected to the same supply lead, all of these will be in programming mode simultaneously. The shutters/awnings/blinds will begin to move up and down “at random”. The longer you take to carry out the programming, the larger the offset will be. Individual channels can now be assigned to the given receiver.
Deleting radio channel settings/ Technical data Adjustment to Pos B Prerequisite: The transmitter has been programmed. 1. Press the UP button twice in quick succession. 2. The drive will adjust the curtain/canopy/blind into the stored intermediate position. If no intermediate position is stored, the curtain/canopy/blind is automatically adjusted into the lower limit position. Deleting individual transmitters Disconnect the fuse – and reconnect after a few seconds.
USA Battery replacement/Cleaning/ Troubleshooting Battery replacement 1. Open the battery compartment. 2. Remove the batteries. 3. Insert the new batteries properly. Cleaning Clean the device with a damp cloth only. Do not use a cleansing agent as doing so may damage the plastic. Troubleshooting Problem Cause Remedy Drive is not functioning. 1. Batteries are empty. Transmission control 2. Batteries are inserted light is not illuminated. incorrectly. 1. Replace batteries 2.
